We are searching data for your request:
Upon completion, a link will appear to access the found materials.
Solutions for energy saving: from lighting to household appliances, here are some valid solutions to spend less on your bill and make the most of a vital resource such as energy.
Solutions to save with lighting
It should be emphasized that the most effective way to save on your bill is not to waste on the lighting of your home: how many of us happen to forget a light on or not to give importance to that small bright LED on the TV and other appliances domestic appliances?
This is an aspect that should not be underestimated given that we are talking about an energy consumption equal to approximately 13.5% of the total electricity consumption in the residential sector.
Another aspect not to be underestimated are the bulbs and lamps: are you sure you have chosen the right lamp and the best position to place it? Remember that turning on too many lights at the same time does not mean that the environment is better illuminated, but rather overheating it.
To save on energy, it is better to opt for low-consumption compact fluorescent lamps with electronic ballast, especially in rooms where the light is kept on the most. Avoid decorating your home with chandeliers with many bulbs: run's single 100 W lamp illuminates six 25 W bulbs, this means consuming half
Solutions to make the best use of appliances
If we do not make a conscious use of the many appliances at our disposal, it will never be possible to save on the bill and pollute less. Small intelligent solutions are enough to reduce consumption by up to 30/50%.
A few examples: do you want to save on the refrigerator? Just place it in the coolest spot in the kitchen, while the freezer should be placed in the garage or cellar. Open the fridge only the bare essentials and if it remains empty, turn it off. Set the thermostat to reasonable temperatures.
The washing machine is one of the appliances that has the greatest impact on home energy consumption, especially for heating the water during washing. Old washing machines turn out to be quite energy-intensive: if you have an old washing machine, don't you think it's time to change it? Modern models have devices to consume less water and detergent as well as energy.
Only use the washing machine with a full load, avoiding programs that use temperatures that are too high. Turn on the air conditioner only if it is really needed. Always pay attention to the label of household appliances: buy those with the lowest consumption of the 'A' type. Perhaps the time has also come to replace the common electric water heater with a gas or solar panel one capable of halving consumption.
Solutions to save with heating
Can you save money with home heating too? Of course, it is enough to focus on adequate thermal insulation of the rooms. For example: you can choose a better insulation of the building, installing double-glazed windows and installing high-performance frames to reduce the infiltration of cold air from outside.
You can insulate the roof with panels or mats of insulating material outside, under the roof tiles or tiles, or inside, in the attic. You can insulate the walls from the inside with panels of insulating material, or even from the outside. Proper maintenance of the heating system in your home is very important and must be checked not close to winter, but already around September / October. Bleed the radiators from the indoor air and once turned on, avoid covering them with curtains and furniture.
As for the boiler, opt for a condensing model that guarantees greater efficiency for the same energy used: it reuses the outgoing gases in the form of condensation, guaranteeing high boiler efficiency.
Solutions to save with water
To reduce daily water consumption, you can install air mixers: applied to showers and taps, they allow you to mix water with air ensuring the same pressure but halved consumption.
Letting the water run when not needed is useless and expensive! When you wash yourself try to manage the taps with intelligence.
The same goes for the toilet flush which generally consumes 10 liters of water for each jet. In order not to waste in this case, you have two possibilities: you can insert a hermetically sealed one-liter water bottle inside the tray, or install a system with a double drain button to use the right amount of water according to need.